LG Electronics LMHM2237ST Installation Guide Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
13
STEP 4: Prepare The Wall & Upper Cabinet
Drill The Holes In The Wall And Upper Cabinet.
1. Drill holes on the circles. If there is a stud, drill a 3/16
"
hole
for lag screws. If there is no stud, drill a 3/4
"
hole for toggle
bolts. Make sure to use at least 1 lag screw in a stud, and
2 toggle screws in the drywall or the plaster.
2. Drill a 3/8 hole at points J and K on the upper cabinet
template.
NOTE: If the bottom of the upper cabinet is recessed 3/4
"
or more, you will need 2
"
x 2
"
filler blocks (not
included) to provide additional support for the bolts.
See Figure 28.
Mark the center of each filler block and drill a 3/8
diameter hole at the marks.
Align filler blocks over the two openings in the top
of the microwave oven cabinet and attach to the
cabinet with masking tape. See Figure 29.
3. Cut or drill a 2
"
diameter hole at the area marked M. Power
supply cord hole on the upper cabinet template. If the upper
cabinet is metal, you will need to cover the edge of the hole
with the power supply cord bushing (supplied) to prevent
damage to the cord from the rough metal edge.
4. Cut out the venting areas (with the saber saw):
Roof-Venting: cut out the shaded area marked L on the
upper cabinet template.
Room-Venting: go to STEP 5, INSTALL THE MOUNTING
PLATE, located on page 14.
5. Complete whichever venting system you have chosen. Use
caulking compound to seal the exterior wall or roof opening
around the wall cap or roof cap.
Figure 28
Figure 29
Cabinet Front
Cabinet
Bottom Shelf
Filler Block
Filler
Block
To avoid risk of personal injury, electric shock or death:
Note where electrical outlets and electrical wires are before you drill into the wall.
Locate and disconnect power to any electrical circuits that could be affected by
installing this oven.
To avoid risk of personal injury, electric shock or death, cover the edge of the power
supply cord hole with the power supply cord bushing.
Wall-Venting: Cut out the shaded area marked F on the
REAR WALL TEMPLATE.
W ARNING
w
W ARNING
w
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments