LG Electronics LMHM2237ST Installation Guide Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 16
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
STEP 3: Prepare The Venting Blower
WALL-VENTING INSTALLATION:
1. Remove one or two blower unit mounting screw(s) and one
or several blower plate mounting screw(s). Remove the
blower plate from the cabinet. See Figure 13.
2. Carefully lift the blower unit out of the microwave oven.
3. Use side cutters or tin snips to cut and remove knockouts
B from Back plate. Discard knockouts. Be careful not to
distort the plate. See Figure 15.
4. Reassemble the blower wire. See Figure 16.
5. Rotate and reinstall the blower unit so that the exhaust
ports face the rear of the cabinet and are aligned with the
rear cut-outs. See Figures 17 & 18.
6. Reattach the blower plate to microwave oven so the exhaust
ports and blower plate opening are aligned. Attach with one
blower unit mounting screw and then one or several blower
plate mounting screw(s). See Figure 19.
7. Insert the tabs on each side of the damper into the holes
at the inside rear of the adaptor.
Attach the exhaust adaptor to the back plate wall side.
Push in securely until it is past the top locking tabs
and in the lower locking tabs. Take care to assure
the damper hinge is installed so that it is at the top
and that the damper swings freely. See Figure 20.
Figure 13
Blower Plate
Mounting Screw
Blower Plate
Back Plate
Blower Unit
Mounting Screw
Blower Unit
Parts B
Figure 14
Blower
Unit
Exhaust Ports
Figure 15
Figure 16
Figure 18
Blower Plate
Mounting Screw
Blower Plate
Back Plate
Blower Unit
Exhaust Ports
Blower Unit
Blower Unit
Mounting Screw
Figure 17
Exhaust
Ports
10
Slide exhaust
adaptor into
guides on
rear panel.
Exhaust Adaptor
Damper
(hinge side up)
Locking
Tabs
Guides
Figure 19
See Figure 14.
Parts B
Knockouts Parts B
Figure 20
or
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments